@cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish • 5 days agoTwo Open Source Projects Combine to 3D Print a Working Replica Key Using a Flipper Zerowww.hackster.ioexternal-linkmessage-square37fedilinkarrow-up1155arrow-down15
arrow-up1150arrow-down1external-linkTwo Open Source Projects Combine to 3D Print a Working Replica Key Using a Flipper Zerowww.hackster.io@cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish • 5 days agomessage-square37fedilink
minus-square@Evil_Shrubbery@lemm.eelinkfedilinkEnglish2•5 days agoOld locks can be brutal to keys, it’s what grinds the steel keys down & at some point even new keys don’t last as long.
minus-square@cynar@lemmy.worldlinkfedilinkEnglish2•5 days agoI fully agree, but most locks aren’t in that state. 95% of the locks you might want to use this technique on would be in a reasonable condition.
minus-square@Evil_Shrubbery@lemm.eelinkfedilinkEnglish1•edit-24 days agoYes, I agree, it’s perfectly fine - jamming the door is more of a phobic anxiety. Then again, 95% of such locks are prob vulnerable to simpler attacks.
Old locks can be brutal to keys, it’s what grinds the steel keys down & at some point even new keys don’t last as long.
I fully agree, but most locks aren’t in that state. 95% of the locks you might want to use this technique on would be in a reasonable condition.
Yes, I agree, it’s perfectly fine - jamming the door is more of a phobic anxiety.
Then again, 95% of such locks are prob vulnerable to simpler attacks.